BOILER FOR HEAT RECOVERY

Utilising Waste Heat in Exhaust Air and Flue Gas

 

 

 


 

AB&CO · TT BOILERS are a well-known Danish boiler manufacturer, who have specialised in small and medium size customised heaters and boilers.

 


AB&CO · CONSULT design and optimise customised heat recovery i.e. exhaust gas boilers, economisers, heat exchangers etc.

A heat recovery solution start on consultant basis by
AB&CO · CONSULT and can be effectuated in manufacturing the equipment by AB&CO · TT BOILERS. This ensures the best solution for customer.
 

main menu


contact



 

   Assistance & Supervising
in Optimising Heat Recovery
   Introduction to Economisers and
Exhaust Gas Heaters & Boilers
   Download :        Booklet about subject
                           'Heat Recovery'
 
   Download :         AB&CO · CONSULT
                   'Your Heat Recovery Partner'
 
   Download :       AB&CO · TT BOILERS
                        'The Boiler Maker'
 
   Useful Link :

TOOLS for thermal engineers

 

 

 

 

 

 

 

 

 

 

 

 

 

INTRODUCTION TO ECONOMISERS & HEAT RECOVERY BOILERS
 
INTRODUCTION  

Flue gas / exhaust gas contains a large amount of heat.  It comes from engines and these often produced flue gas at very high temperatures - or it comes from fired heaters where the flue gas temperatures is somewhat lower, but often the amount of exhaust gas is much larger.

Instead of wasting the heat, the boilers and heaters for heat recovery offer very good opportunities for utilising the waste heat for production of steam, hot thermal oil or hot water.
 


 

Today process heat recovery offers substantial economical advantages - due to reduction of CO2 and saving the fuel. Furthermore heat recovery gives a good environmental profile, that is required by many authorities and business contacts.
 

The engineers of AB&CO · CONSULT and AB&CO · TT BOILERS have many years experience ensuring optimum solution for customers. 

 

Heat recovery of process heat can be utilised in many type of heat exchangers - not limited to boilers as this chapter describe.

Boilers and heaters for heat recovery, are also called economisers.

Basically these are heat exchangers. The output depend on the size and design of the unit, but most of all it depends of the flue gas temperature, flue gas amount and the thermal properties on the other side. This means that the very hot flue gas from engines permits production of high pressure steam steam and high temperature thermal oil, while the colder flue gas from heaters and boilers only permits heating of water at moderate temperatures.

Like heat exchangers in general, the same output the economiser can result in small and short, long and narrow, or big and width units. The design change from case to case.

Below is an example of a heating system with an economiser operating as a steam boiler - a special economiser steam boiler system.



Economisers installed on TT BOILERS thermal oil heaters
Supply of skid-mounted hot oil systems for China, Thailand and Malaysia

 

  
More info about
  the 'Boiler Works'


 

 

TT BOILERS Flue Gas Steam Boiler with by-pass
Left :  Ready for Delivery         Right : Illustration

 

 

Boilers and heat exchangers for heat recovery is very often  a part of a total system.
An example of a recuperative steam boilers system is shown below
.

wpe8.jpg (46432 bytes)

 

main menu                                                 contact